Configuration Handbook - Kamami.pl

Configuring Stratix III DevicesFigure 11–15. In-System Programming of Serial Configuration Devices(1) (1) (1)10 kΩ 10 kΩ 10 kΩStratix III FPGACONF_DONESerialConfigurationDevicenSTATUSnCONFIGnCEnCEON.C.10 kΩV CC V CC V CCV CCDATADATA0V CCDCLKnCSDCLKnCSOMSEL2MSEL1ASDIASDOMSEL0GNDPin 1(2)USB Blaster or ByteBlaser II(AS Mode)10-Pin Male HeaderNotes to Figure 11–15:(1) Connect these pull-up resistors to 3.0-V supply.(2) Power up the ByteBlaster II cable's V CC with a 3.0-V supply.You can program serial configuration devices with the Quartus IIsoftware using the Altera programming hardware and the appropriateconfiguration device programming adapter.In production environments, you can program serial configurationdevices using multiple methods. You can use Altera programminghardware or other third-party programming hardware to program blankserial configuration devices before they are mounted onto printed circuitboards (PCBs). Alternatively, you can use an on-board microprocessor toprogram the serial configuration device in-system using C-basedsoftware drivers provided by Altera.You can program a serial configuration device in-system by an externalmicroprocessor using SRunner. SRunner is a software driver developedfor embedded serial configuration device programming, which can beeasily customized to fit in different embedded systems. SRunner is able toread a raw programming data (.rpd) file and write to the serialAltera Corporation 11–39May 2007 Stratix III Device Handbook, Volume 1