12.07.2015 Views

Configuration Handbook - Kamami.pl

Configuration Handbook - Kamami.pl

Configuration Handbook - Kamami.pl

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Device <strong>Configuration</strong> OptionsTable 6–1. <strong>Configuration</strong> Options (Part 5 of 5)Device OptionGeneratecompressedbitstreams(Stratix II andCyclone seriesdevices only)Auto usercode(Not available inFLEX 6000devices.)Option UsageEnables Stratix II andCyclone series FPGAs toreceive compressedconfiguration bitstreams inAS and PS configurationschemes.Allows you to program a 32-bit user electronic signatureinto the device duringprogramming (typically fordesign version control).When the USERCODEinstruction is loaded into thedevice, you can shift thesignature out of the device.Default <strong>Configuration</strong>(Option Off)The Quartus II softwaregenerates uncompressedprogramming files andStratix II and Cyclone seriesFPGAs do not decompressthe configuration data.If this option is off, the JTAGuser code option is availableand you can specify a 32-bithexadecimal number for thetarget device. The JTAG usercode is an extension of theoption register. This data canbe read with the JTAGUSERCODE instruction.Modified <strong>Configuration</strong>(Option On)The Quartus II softwaregenerates compressedprogramming files andStratix II and Cyclone seriesFPGAs decompress thebitstream duringconfiguration.Uses the checksum valuefrom the SRAM Object File(.sof) as the JTAG user code.If this option is on, the JTAGuser code option is dimmedto indicate that it is notavailable.After enhanced configuration and EPC2 device programming you canchoose to automatically configure the targeted FPGAs on board. This canbe done by selecting the Initiate <strong>Configuration</strong> After Programmingoption under the Programmer section of the Options window (Toolsmenu). This option is similar to issuing the INIT_CONF JTAG instruction,which means nINIT_CONF of the enhanced configuration or EPC2devices must be connected to the nCONFIG of the FPGA.fFor more information on the INIT_CONF JTAG instruction, refer to theEnhanced <strong>Configuration</strong> devices Data Sheet or the <strong>Configuration</strong> Devices forSRAM-Based LUT Devices Data Sheet.Altera Corporation 6–9April 2007 <strong>Configuration</strong> <strong>Handbook</strong>, Volume 2

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!