13.07.2015 Views

ARM Cortex-A15 MPCore Processor Technical Reference Manual

ARM Cortex-A15 MPCore Processor Technical Reference Manual

ARM Cortex-A15 MPCore Processor Technical Reference Manual

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Signal DescriptionsA.7 WFE and WFI standby signalsSignal Type DescriptionTable A-6 shows the WFE and WFI standby signals. The value of N is one less than the numberof processors in your design.Table A-6 WFE and WFI standby signalsEVENTI Input Event input for processor wake-up from WFE standby mode. When this signal is asserted, it actsas a WFE wake-up event to all the processors in the <strong>MPCore</strong> device. This signal must beasserted for at least one CLK cycle. See Event communication using WFE and SEV instructionson page 2-37 for more information.EVENTO Output Event output. This signal is asserted HIGH for three CLK cycles when any of the processors inthe <strong>MPCore</strong> device executes an SEV instruction. See Event communication using WFE and SEVinstructions on page 2-37 for more information.STANDBYWFE[N:0] Output Indicates if a processor is in WFE standby mode:0 <strong>Processor</strong> not in WFE standby mode.1 <strong>Processor</strong> in WFE standby mode.STANDBYWFI[N:0] Output Indicates if a processor is in WFI standby mode:0 <strong>Processor</strong> not in WFI standby mode.1 <strong>Processor</strong> in WFI standby mode.STANDBYWFIL2 Output Indicates if L2 is in WFI standby mode. This signal is active when the following are true:• All processors are in standby WFI.• ACINACTM and AINACTS are asserted HIGH.• L2 is idle.<strong>ARM</strong> DDI 0438I Copyright © 2011-2013 <strong>ARM</strong>. All rights reserved. A-9ID062913Non-Confidential

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!