R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
ASCII FILE
EXPORT
Analyzer Mode
For correct power averaging with units VOLT or AMPERE, selection POWER has
to be used.
The ASCII FILE EXPORT softkey stores the active trace in ASCII format, e.g. on a
memory stick.
Remote command: FORM ASC;
MMEM:STOR:TRAC 1,'TRACE.DAT'
The file consists of the header containing important scaling parameters and a data
section containing the trace data.
The data of the file header consist of three columns, each separated by a semicolon:
parameter name; numeric value; base unit
The data section starts with the key word " Trace " ( = number of stored
trace), followed by the measured data in one or several columns (depending on
measurement) which are also separated by a semicolon.
This format can be read in from spreadsheet calculation programs, e.g. MS-Excel. It
is necessary to define ';' as a separator.
Different language versions of evaluation programs may require a different handling
of the decimal point. It is therefore possible to select between separators '.'
(decimal point) and ',' (comma) using the DECIM SEP softkey.
Operating Manual 1313.9681.12 - 01 4.45