R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
6.18 STATus Subsystem
STATus Subsystem
The STATus subsystem contains the commands for the status reporting system (see chapter “Remote
Control – Basics”, section “Status Reporting System” on page 5.19). *RST does not influence the status
registers.
STATus:OPERation:CONDition?
This command queries the CONDition section of the STATus:OPERation register. Readout does not
delete the contents of the CONDition section. The value returned reflects the current hardware status.
Return value: see “STATus:OPERation Register” on page 5.25
Example: "STAT:OPER:COND?"
Characteristics: *RST value: –
SCPI: conform
Mode: A
STATus:OPERation:ENABle 0 to 65535
This command sets the bits of the ENABle section of the STATus:OPERation register. The ENABle
register selectively enables the individual events of the associated EVENt section for the summary bit
in the status byte.
Example: "STAT:OPER:ENAB 65535"
Characteristics: *RST value: –
SCPI: conform
Mode: A
STATus:OPERation[:EVENt]?
This command queries the contents of the EVENt section of the STATus:OPERation register. The
contents of the EVENt section are deleted after readout.
Example: "STAT:OPER?"
Characteristics: *RST value: –
SCPI: conform
Mode: A
STATus:OPERation:NTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:OPERation register from 1 to 0 for the
transitions of the CONDition bit.
Example: "STAT:OPER:NTR 65535"
Characteristics: *RST value: –
SCPI: conform
Mode: A
6.218 Operating Manual 1313.9681.12 - 01