R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Mode: A
SOURce:EXTernal:ROSCillator[:SOURce] INTernal | EXTernal
SOURce Subsystem
This command switches between external and internal reference oscillator for the frequency
processing of external generator 1 and 2.
The command always works on both generators. Therefore, the numeric suffix in EXTernal is not
significant.
This command is only valid in combination with option Ext. Generator Control R&S FSP-B10.
Example: "SOUR:EXT:ROSC EXT"
'switches to external reference oscillator
Characteristics: *RST value: INT
SCPI: device-specific
Mode: A
This command is available from firmware version 1.40 or higher.
SOURce:EXTernal[:STATe] ON | OFF
This command activates or deactivates the external generator selected with SOUR:EXT:FREQ:
SWE ON in the selected window.
The suffix behind EXTernal is irrelevant for this command.
This command is only available in connection with option Ext. Generator Control B10.
Example: "SYST:COMM:RDEV:GEN1:TYPE 'SMP02'"
'Selects SMP02 as generator 1.
"SYST:COMM:RDEV:GEN1:LINK TTL"
'Selects GPIB + TTL link as interface.
"SYST:COMM:RDEV:GEN1:ADDR 28"
'Sets the generator address to 28.
"SOUR:EXT1:FREQ:SWE ON"
'Activates the frequency sweep for generator 1.
"SOUR:EXT ON"
'Activates the external generator
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
Operating Manual 1313.9681.12 - 01 6.217