R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
"CALC2:DELT:TRAC 3"
'Assigns delta marker 1 to trace 3 in screen B.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
CALCulate:DELTamarker:X 0 to MAX (frequency | sweep time)
CALCulate Subsystem
This command positions the selected delta marker in the indicated measurement window to the
indicated frequency (span > 0), time (span = 0) or level (APD measurement = ON or CCDF
measurement = ON). The input is in absolute values or relative to marker 1 depending on the
command CALCulate:DELTamarker:MODE. If the reference fixed measurement (CALCulate:
DELTamarker:FUNCtion:FIXed:STATe ON) is active, relative values refer to the reference
position are entered. The query always returns absolute values.
Example: "CALC:DELT:MOD REL"
'Switches the input for all delta markers to relative to marker 1.
"CALC:DELT2:X 10.7MHz"
'Positions delta marker 2 in screen A 10.7 MHz to the right of marker 1.
"CALC2:DELT:X?"
'Outputs the absolute frequency/time of delta marker 1 in screen B
"CALC2:DELT:X:REL?"
'Outputs the relative frequency/time/level of delta marker 1 in screen B
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
CALCulate:DELTamarker:X:RELative?
This command queries the frequency (span > 0) or time (span = 0) of the selected delta marker relative
to marker 1 or to the reference position (for CALCulate:DELTamarker:FUNCtion:FIXed:STATe
ON). The command activates the corresponding delta marker, if necessary.
Example: "CALC:DELT3:X:REL?"
'Outputs the frequency of delta marker 3 in screen B relative to marker 1 or relative
to the reference position.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
CALCulate:DELTamarker:Y?
This command queries the measured value of the selected delta marker in the indicated measurement
window. The corresponding delta marker will be activated, if necessary. The output is always a relative
value referred to marker 1 or to the reference position (reference fixed active).
To obtain a valid query result, a complete sweep with synchronization to the sweep end must be
performed between the activation of the delta marker and the query of the y value. This is only possible
in single-sweep mode.
Depending on the unit defined with CALC:UNIT or on the activated measuring functions, the query
result is output in the units below:
6.20 Operating Manual 1313.9681.12 - 01