R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
Basic Settings
For 8566A/B, 8568A/B and 8594E, command sets A and B are available. Command
sets A and B differ in the rules regarding the command structure from the
command structure of “SCPI”. Therefore, correct recognition of SCPI commands is
not ensured in these operating modes.
Selecting a language different from "SCPI" will set the GPIB address to 18 if it was
20 before.
Start / stop frequency, reference level and # of sweep points will be adapted to the
selected instrument model.
8568A_DC and 8568B_DC are using DC input coupling as default if it is supported
by the instrument.
The HP model 8591E is compatible to HP model 8594E, the HP models 71100C,
71200C, and 71209A are compatible to HP models 8566A/B.
On switching between remote-control languages, the following settings or changes
will be made:
SCPI:
➢ The instrument will perform a PRESET.
8566A/B, 8568A/B, 8594E:
➢ The instrument will perform a PRESET.
➢ The following instrument settings will then be changed:
Model # of Trace
Points
Start Freq. Stop Freq. Ref Level Input
Coupling
8566A/B 1001 2 GHz 22 GHz 0 dBm DC
8568A/B 1001 0 Hz 1.5 GHz 0 dBm AC
8560E 601 0 Hz 2.9 GHz 0 dBm AC
8561E 601 0 Hz 6.5 GHz 0 dBm AC
8562E 601 0 Hz 13.2 GHz 0 dBm AC
8563E 601 0 Hz 26.5 GHz 0 dBm AC
8564E 601 0 Hz 40 GHz 0 dBm AC
8565E 601 0 Hz 50 GHz 0 dBm AC
8594E 401 0 Hz 3 GHz 0 dBm AC
Notes regarding switch over to 8566A/B and 8568A/B on R&S FSUP
• The stop frequency indicated in the table may be limited to the corresponding
frequency of the R&S FSQ, if required.
Remote command: SYST:LANG "SCPI" | "8560E" | "8561E" |
"8562E" | "8563E" | "8564E" | "8565E" |
"8566A" | "8566B" | "8568A" |
"8568A_DC" | "8568B" | "8568B_DC" |
"8591E" | "8594E" | "71100C" | "71200C" |
"71209A"
Operating Manual 1313.9681.12 - 01 4.185