R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
• Transd. Factor
Analyzer Mode
Shows the name of the transducer factor that is used for the measurement, or
NONE if no transducer factor is selected.
To select a transducer factor highlight this field with the rotary knob and press the
ENTER key to open the transducer selection list. Select the name of the
transducer factor you need with the rotary knob or NONE if you have to work
without a transducer factor.
Remote command: ESP:RANG1:TRAN
• Limit Check
Sets the type of limit check for all ranges.
ABSOLUTE:
Checks only the defined absolute limits.
RELATIVE:
Checks only the relative limits. Relative limits are defined as relative to the
measured power in the reference range.
ABS & REL:
Combines the absolute and relative limit. The limit check fails when both limits are
violated.
ABS or REL:
Combines the absolute and relative limit. The limit check fails when one of the
limits is violated.
Remote command: ESP:RANG1:LIM:STAT ABS | REL | AND | OR
• Abs Limit Start
Sets the absolute limit value at the start frequency of the range. The unit depends
on the unit selected via the UNIT softkey.
Remote command: ESP:RANG1:LIM:ABS:STAR 10
• Abs Limit Stop
Sets the absolute limit value at the stop frequency of the range. The unit depends
on the unit selected via the UNIT softkey.
Remote command: ESP:RANG1:LIM:ABS:STOP 20
• Rel Limit Start
Sets the relative limit value at the start frequency of the range. The unit is dBc.
Remote command: ESP:RANG1:LIM:REL:STAR -20
• Rel Limit Stop
Sets the relative limit value at the stop frequency of the range. The unit is dBc.
Remote command: ESP:RANG1:LIM:REL:STOP -20
Operating Manual 1313.9681.12 - 01 4.149