R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
NEW
FACTOR /
EDIT TRD FAC
TOR
Basic Settings
• The frequencies entered may exceed the frequency range of the R&S FSQ since
only the set frequency range is taken into account for measurements. The
minimum frequency of a reference value is 0 Hz, the maximum frequency
200 GHz.
• The value range for the transducer factor is ±200 dB. If the minimum or maximum
value is exceeded, the R&S FSQ outputs the following message:
out of range
• Gain has to be entered as a negative value, and attenuation as a positive value.
The softkeys in the UNIT submenu of the AMPT key cannot be operated if the
transducer is on.
The NEW FACTOR and EDIT TRD FACTOR softkeys give access to the submenu
for editing and generating transducer factors.
TRD FACTOR NAME
TRD FACTOR UNIT
TRD FACTOR VALUES
INSERT LINE
DELETE LINE
SAVE TRD FACTOR
Depending on the softkey selected, either the table with the data of the factor
marked (EDIT TRD FACTOR softkey) or an empty table (NEW FACTOR softkey) is
displayed. This table is empty except for the following entries:
Unit: dB
Interpolation: LIN for linear frequency scaling
LOG for logarithmic frequency scaling
The features of the factor are entered in the header of the table, and the frequency
and the transducer factor are entered in the columns.
Name Entry of name
Unit Selection of unit
Interpolation Selection of interpolation
Comment Entry of comment
FREQUENCY Entry of frequency of reference values
TDF/dB Entry of transducer factor.
4.180 Operating Manual 1313.9681.12 - 01