R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
CALCulate Subsystem
"CALC:MARK:FUNC:FPE:COUN?"
'queries the number of maxima found
"CALC:MARK:FUNC:FPE:Y?"
'queries the level of maxima found
"CALC:MARK:FUNC:FPE:X?"
'queries the frequencies (span 0) or time (span = 0) of maxima found.
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
CALCulate:MARKer:FUNCtion:FPEaks:LIST:SIZE 1 to 50
This command sets the maximum length of the peak list.
Alternately to this command you can use CALCulate:MARKer:FUNCtion:FPEaks[:
IMMediate] to set the number of peaks.
The number of maxima found depends on the waveform and value set for the Peak Excursion
parameter (CALC:MARK:PEXC), however, a maximum number of 50 maxima are determined. Only the
signals which exceed their surrounding values at least by the value indicated by the peak excursion
parameter will be recognized as maxima. Therefore, the number of maxima found is not automatically
the same as the number of maxima desired.
The numeric suffix at MARKer is irrelevant.
Example: "CALC:MARK:FUNC:FPE:LIST:SIZE 12"
'searches for 12 peaks.
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
CALCulate:MARKer:FUNCtion:FPEaks:SEARch:AUTO ON | OFF
This command activates and deactivates automatic peaks search after a sweep is done.
The numeric suffix at MARKer is irrelevant.
Example: "INIT:CONT OFF"
'starts single sweep mode.
"CALC:MARK:FUNC:FPE:STAT ON"
'activate peak list.
"CALC:MARK:FUNC:FPE:SEAR:AUTO ON"
'starts peak list auto search.
Characteristics: *RST value: ON
SCPI: device-specific
Mode: A
Operating Manual 1313.9681.12 - 01 6.65