R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
Basic Settings
OPTIONS Opens a table that provides information about installed firmware options. Also opens
a submenu to manage firmware options.
INSTALL
OPTION
REMOVE
OPTION
INSTALL OPTION
REMOVE OPTION
EXPERT MODE
REBOOT
PAGE UP /
PAGE DOWN
INSTALL (FW EXT)
The INSTALL OPTION softkey opens the data entry for the license keycode of a
firmware option.
On entry of a valid license key the message OPTION KEY OK is displayed in the
status line and the firmware option appears in table FIRMWARE OPTIONS.
If the license key is valid and accepted, the R&S FSQ activates that option by
default. If the R&S FSQ has memory issues, you have to deactivate other applications
before you can use the option (see OPTIONS softkey).
On entry of an invalid license key the message OPTION KEY INVALID is displayed
in the status line.
Remote command: --
The REMOVE OPTION softkey removes all firmware options from the instruments.
Execution of this function must be confirmed in a message box in order to avoid
removal of the firmware options by mistake.
Remote command: --
EXPERT MODE The EXPERT MODE softkey switches off the option key memory check.
This function is useful if all the required applications do not fit into the available system
memory, but the worst case settings (concerning memory usage) of the applications
is not required for a certain test case.
Example: An application may only need the maxmimum memory if a certain function
(e.g. FFT calculation) is active. If this function is not used, it is possible to enable an
additional application.
The analyzer may crash do to "low memory" conditions if the expert mode is
switched on.
Remote command: ---
REBOOT The REBOOT softkey performs the shutdown and reboot of the operating system
and the analyzer firmware. The reboot will free allocated resources.
Remote command: ---
4.194 Operating Manual 1313.9681.12 - 01