R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Example: "CALC:MARK:FUNC:HARM:PRES"
'Optimizes the device setting for the measurement of harmonics.
Characteristics: *RST value: --
SCPI: device-specific
This command is an event and therefore has no *RST value and no query.
Mode: A-F, A-T
CALCulate Subsystem
CALCulate:MARKer:FUNCtion:HARMonics[:STATe] ON | OFF
This command switches on or off the measurement of the harmonics of a carrier signal. The carrier
signal is the first harmonic. The function is independent of the marker selection, i.e. the suffix
or of CALCulate or MARKer is irrelevant. It is only available in the frequency domain (span >
0).
If the measurement is started in the frequency domain (span > 0), the last span will define the search
range for the first harmonic. The level for the first harmonic will also be calculated in the frequency
domain. However, the measurement can also be started in the time domain (span = 0), in which case
the center frequency and the level used will remain unchanged.
Example: "CALC:MARK:FUNC:HARM ON"
'Switches on the measurement of harmonics.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A-F^
6.70 Operating Manual 1313.9681.12 - 01