R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
SYSTem:PRESet
This command initiates an instrument reset.
SYSTem Subsystem
The effect of this command corresponds to that of the PRESET key with manual operation or to the
*RST command.
Example: "SYST:PRES"
Characteristics: *RST value: –
SCPI: conform
Mode: A
SYSTem:REVision:FACTory
This command selects the default response for remote commans “REV?”.It can only be selected in HP
emulation mode.
This command is an event and therefore has no query and no *RST value.
Example: "SYST:REV:FACT"
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
SYSTem:REVision[:STRing]
This command defines the output string for remote command “REV?” in HP emulation mode. The
maximum number of characters is 40.
SYSTem:REVision:FACTory resets this response to it's default.
Example: "SYST:REV '12345'"
"REV?” returns '12345'
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
SYSTem:RSWeep ON | OFF
This command controls a repeated sweep of the E1 and MKPK HI HP model commands. If the
repeated sweep is OFF, the marker is set without sweeping before.
Example: "SYST:RSW:ON"
'Sets the repeated sweep on.
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
SYSTem:SHUTdown
This command shuts down the instrument.
This command is an event and therefore has no query and no *RST value.
Example: "SYST:SHUT"
Operating Manual 1313.9681.12 - 01 6.237