R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
ACP LIMIT
CHECK
EDIT ACP
LIMITS
Analyzer Mode
The ACP LIMIT CHECK softkey switches the limit check for the ACP measurement
on and off.
Remote command: CALC:LIM:ACP ON
CALC:LIM:ACP:ACH:RES?
CALC:LIM:ACP:ALT:RES?
The EDIT ACP LIMITS softkey opens a table for defining the limits for the ACP measurement.
The following rules apply for the limits:
• A separate limit can be defined for each adjacent channel. The limit applies to both
the upper and the lower adjacent channel.
• A relative and/or absolute limit can be defined. The check of both limit values can
be activated independently.
• The R&S FSQ checks adherence to the limits irrespective of whether the limits are
absolute or relative or whether the measurement is carried out with absolute or
relative levels. If both limits are active and if the higher of both limit values is
exceeded, the measured value is marked accordingly.
Measured values exceeding the limit are marked by a preceding asterisk.
Remote command: CALC:LIM:ACP ON
CALC:LIM:ACP:ACH 0dB,0dB
CALC:LIM:ACP:ACH:STAT ON
CALC:LIM:ACP:ACH:ABS –10dBm,-10dBm
CALC:LIM:ACP:ACH:ABS:STAT ON
CALC:LIM:ACP:ALT1 0dB,0dB
CALC:LIM:ACP:ALT1:STAT ON
CALC:LIM:ACP:ALT1:ABS –10dBm,-10dBm
CALC:LIM:ACP:ALT1:ABS:STAT ON
CALC:LIM:ACP:ALT2 0dB,0dB
CALC:LIM:ACP:ALT2:STAT ON
CALC:LIM:ACP:ALT2:ABS –10dBm,-10dBm
CALC:LIM:ACP:ALT2:ABS:STAT ON
Operating Manual 1313.9681.12 - 01 4.101