R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
External Generator Control – Option R&S FSP-B10
RECALL The RECALL softkey restores the instrument setting with which the calibration was
carried out.
This can be useful if the device setting was changed after calibration (e.g. center frequency
setting, frequency deviation, reference level, etc.).
The softkey is only available if:
• the NETWORK mode has been selected
• the memory contains a calibration data set.
SAVE AS TRD
FACTOR
Remote command: CORR:REC
SAVE AS TRD FACTOR uses the normalized measurement data to generate a
transducer factor with up to 625 points. The trace data are converted to a transducer
with unit dB after the transducer name has been entered. The number of points is
defined by SWEEP COUNT. The frequency points are allocated in equidistant steps
between start and stop frequency. The generated transducer factor can be further
adapted in the menu SETUP – TRANSDUCER. SAVE AS TRD FACTOR is only
available if normalization is switched on.
Remote command: CORR:TRAN:GEN '
4.8.3 Reflection Measurement
Scalar reflection measurements can be carried out by means of a reflection-coefficient
bridge.
Fig. 4.34 Test setup for reflection measurement
4.8.3.1 Calibration of Reflection Measurement
The calibration mechanism essentially corresponds to that of the transmission measurement.
CAL REFL
SHORT
The CAL REFL SHORT softkey starts the short-circuit calibration.
If both calibrations (open circuit, short circuit) are carried out, the calibration curve is
formed by averaging the two measurements and stored in the memory. The order of
measurements is optional.
After the calibration the following message is displayed:
4.242 Operating Manual 1313.9681.12 - 01