R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Characteristics: *RST value: SINGle
SCPI: device-specific
Mode: A
DISPlay:LOGO ON | OFF
This command switches the company logo on the screen on or off.
Example: "DISP:LOGO OFF"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: A
DISPlay:PSAVe:HOLDoff 1 to 60
DISPlay Subsystem
This command sets the hold off time for the power-save mode of the display. The available value range
is 1 to 60 minutes, the resolution 1 minute. The entry is dimensionless.
Example: "DISP:PSAV:HOLD 30"
Characteristics: *RST value: 15
SCPI: device-specific
Mode: A
DISPlay:PSAVe[:STATe] ON | OFF
This command switches on or off the power-save mode of the display. With the power-save mode
activated the display including backlight is completely switched off after the elapse of the response
time (see command DISPlay:PSAVe:HOLDoff).
Example: "DISP:PSAVe ON"
'Switches on the power-save mode.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
DISPlay[:WINDow]:ACTive?
This mode is recommended for preserving the display especially if the instrument
is exclusively operated via remote control.
This command returns the active measurement window. The numeric response has following
meaning:
1 Screen A
2 Screen B
3 Screen C
4 Screen D
Example: "DISP:WIND:ACT?"
returns the active window
6.108 Operating Manual 1313.9681.12 - 01