R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
[SENSe:]ESPectrum:RANGe:COUNt?
SENSe Subsystem
This command indicates the number of defined ranges of the Spectrum Emission Mask measurement.
The numeric suffixes at SENSe and at RANGe are irrelevant for this command.
Example: "ESP:RANG:COUN?"
'indicates the number of ranges
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
[SENSe:]ESPectrum:RANGe:DELete
This command deletes a range of the Spectrum Emission Mask measurement configuration.
The numeric suffixes specify the range. The numeric suffix at SENSe is irrelevant.
Example: "ESP:RANG2:DEL"
'deletes range 2
Characteristics: *RST value:-
SCPI: device-specific
Mode: A
[SENSe:]ESPectrum:RANGe:FILTer:TYPE NORMal | CFILter | RRC | P5 | P5Digital
This command sets the filter in the Spectrum Emission Mask measurement. For details on filter type
refer to “Filter Types” on page 4.26.
The numeric suffixes specify the range. The numeric suffix at SENSe is irrelevant.
Example: "ESP:RANG2:FILT:TYPE RRC"
'RRC filter
Characteristics: *RST value: NORMal
SCPI: device-specific
Mode: A
[SENSe:]ESPectrum:RANGe[:FREQuency]:STARt
This command sets the relative start frequency of a range in the Spectrum Emission Mask
measurement.
The numeric suffixes specify the range. The numeric suffix at SENSe is irrelevant.
Example: "ESP:RANG2:STAR -2.52MHz"
'start frequency of range 2 to -2.52 MHz
Characteristics: *RST value:-
SCPI: device-specific
Mode: A
6.164 Operating Manual 1313.9681.12 - 01