R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Example: "SWE:EGAT:TRAC2:STAT1 ON"
’Range 1 for trace 2 is switched on.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
[SENSe:]SWEep:EGATe:TYPE LEVel | EDGE
SENSe Subsystem
This command sets the type of triggering (level or edge) by the external gate signal.
The gate opening time cannot be defined with the parameter EGATe:LENGth in case of level
triggering. The gate is closed when the gate signal disappears.
Example: "SWE:EGAT:TYPE EDGE"
Characteristics: *RST value: EDGE
SCPI: device-specific
Mode: A
[SENSe]:SWEep:IF:SHIFt OFF | A | B | AUTO
This command activates or deactivates 1st IF shifting. For further details refer to “IF SHIFT” on
page 4.205.
IF SHIFT AUTO automatically selects the suitable 1st IF shifting. The Signal Frequency has to
specified for that purpose in the Signal Frequency dialog.
Input signals at a frequency of half the 1st IF (in the frequency range of 2270 MHz to 2350 MHz) will
reduce the dynamic range of the analyzer. This problem only occurs for low RF attenuation values. It
can be overcome by shifting the 1st IF.
Parameter: OFF: deactives the 1st IF shifting
A: activates the 1st IF shifting for input signals in the frequency range of 2270 MHz
to 2310 MHz
B: activates the 1st IF shifting for input signals in the frequency range of 2310 MHz
to 2350 MHz
AUTO: automatically selects the suitable 1st IF shifting. The Signal Frequency has
to specified for that purpose in the Signal
Parameter: Frequency dialog.
Example: "SWE:IF:SHIF AUTO"
’Sets the IF shift to mode AUTO.
"SWE:IF:SHIF:FREQ "
’Specifies the signal frequency for IF SHIFT AUTO.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
The 1st IF shifting is automatically done for ACP measurements if center frequency
( = signal frequency) is in the range of 2270 MHz … 2350 MHz. The IF SHIFT setting
is therefore ignored for ACP measurements.
Operating Manual 1313.9681.12 - 01 6.209