R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
This command is only available for option R&S FSU-B21 and external mixer activated.
[SENSe:]MIXer:HARMonic:TYPE ODD | EVEN | EODD
This command sets the type of harmonic.
Example: "MIX ON"
"MIX:HARM:TYPE EODD"
Characteristics: *RST value: EVEN
SCPI: device-specific
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
[SENSe:]MIXer:LOPower
SENSe Subsystem
This command changes the LO level of the external mixer LO port from 13.0 dBm to 17.0 dBm in 0.1
dB steps. Default value is 15.5 dB.
Example: "MIX ON"
"MIX ON"
"MIX:LOP 16.0DBM"
Characteristics: *RST value: 15.5 dBm
SCPI: device-specific
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
[SENSe:]MIXer:LOSS:HIGH
This command sets the conversion loss of the mixer for higher harmonics in bands with two harmonics.
Example: "MIX ON"
"MIX:LOSS:HIGH -14DB"
Characteristics: *RST value: 0 dB
SCPI: device-specific
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
[SENSe:]MIXer:LOSS[:LOW]
This command sets the conversion loss of the mixer. If two harmonics are used for the band, it is set
for the lower harmonic.
Example: "MIX ON"
"MIX:LOSS -12DB"
Characteristics: *RST value: 0 dB
SCPI: conform
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
Operating Manual 1313.9681.12 - 01 6.187