R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Example: "DISP:TEXT:STAT ON"
'Switches on the title of screen B.
Characteristics: *RST value: OFF
SCPI: conform
Mode: A
DISPlay[:WINDow]:TIME ON | OFF
DISPlay Subsystem
This command switches on or off the screen display of date and time. The numeric suffix in
WINDow is irrelevant.
Example: "DISP:TIME ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
DISPlay[:WINDow]:TRACe:CLEar
This command clears all active traces.
Clearing all traces is useful, e.g. when you perform a peak search using the current trace buffer before
the end of the sweep. The search is not influenced by the part of the trace that has not yet been
updated.
The numeric suffix at TRACe is irrelevant.
This command is an event and therefore has no query.
Example: "*RST"
'Preset the R&S FSQ.
"FREQ:CENT 1GHZ"
"FREQ:SPAN 100MHZ"
"SWE:TIME 5 s"
'set the center frequency, span and sweep time.
"DISP:TRAC1:MODE MAXH"
"DISP:TRAC2:MODE WRIT"
'set the trace mode for trace 1 and trace 2.
"INIT:CONT OFF"
'select single sweep mode
"DISP:TRAC:CLE"
'clear all traces.
"INIT:IMM"
'start the sweep.
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
DISPlay[:WINDow]:TRACe:MODE WRITe | VIEW | AVERage | MAXHold | MINHold
This command defines the type of display and the evaluation of the traces in the selected
measurement window. WRITE corresponds to the Clr/Write mode of manual operation.
6.110 Operating Manual 1313.9681.12 - 01