R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
6.16.3 SENSe:CORRection Subsystem
SENSe Subsystem
This subsystem also controls calibration and normalization during operation with the external generator
control option (B10). The measurement windows are selected by SENSe1 (screen A) and SENSe2
(screen B).
[SENSe:]CORRection:COLLect[:ACQuire] THRough | OPEN
When the tracking generator is active, this command determines the type of result acquisition for the
normalization reference measurement and starts the measurement selected:
Parameter: THRough:
TRANsmission mode: calibration with direct connection between tracking
generator and device input.
REFLection mode: calibration with short circuit at the input
OPEN: only valid in REFLection mode: calibration with open input
Example: "INIT:CONT OFF"
'Selects single sweep operation
"CORR:COLL THR;*WAI"
'Starts the measurement of reference data using direct connection between
generator and device input and waits for the sweep end.
Characteristics: *RST value: --
SCPI: conform
Mode: A
This command is an "event" and therefore has no *RST value and no query.
This command is only valid in conjunction with the ext. generator control option (B10).
[SENSe:]CORRection:CVL:BAND A|Q|U|V|E|W|F|D|G|Y|J|USER
This command defines the waveguide band in the Conversion Loss Table. Prior to this command, the
command SENS:CORR:CVL:SEL must be sent.
Example: "CORR:CVL:SEL 'LOSS_TAB'"
"CORR:CVL:BAND E"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is only available with the option R&S FSU-B21.
[SENSe:]CORRection:CVL:BIAS
This command defines the bias current in the Conversion Loss Table. Prior to this command, the
command SENS:CORR:CVL:SEL must be sent.
Example: "CORR:CVL:SEL 'LOSS_TAB'"
"CORR:CVL:BIAS 7mA"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is only available with the option R&S FSU-B21.
Operating Manual 1313.9681.12 - 01 6.153