R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
6.15 OUTPut Subsystem
The OUTPut subsystem controls the output features of the instrument.
OUTPut Subsystem
In conjunction with the tracking generator option, a distinction is made between OUTPut1 (screen A) and
OUTPut2 (screen B).
OUTPutDIQ:CDEVice?
This command queries the current configuration and the status of the digital baseband output of option
R&S FSQ-B17.
The return values include the name and serial number of the connected device, the port name and the
sample rate. The values are separated by commas.
The numeric suffix at INPut is irrelevant.
This command is a query and therefore has no *RST value.
This command is valid only in conjunction with the B17 option, LVDS interface.
A return value would look like: "AMU200A,100266,In A,81600000.0"
Example: "OUTP:DIQ:CDEV?"
Returns the current digital baseband configuration.
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
OUTPut:DIQ[:STATe] ON | OFF
This command switches the digital LVDS output on or off.
The numeric suffix at OUTPut is irrelevant.
This command is valid only in conjunction with the B17 option, LVDS interface.
Example: "TRAC:IQ:STAT ON"
'Activares I/Q measurement mode.
"FREQ:CENT 5GHZ"
"DISP:TRAC:Y:RLEV -10"
'Setx the center frequency and reference level of the R&S FSQ.
"TRAC:IQ:SET NORM,50MHZ,36MHZ,EXT,POS,0,1000"
'Configures the I/Q measurement (filter type, RBW, sample rate, trigger source,
trigger slope, pretrigger samples, number of samples).
"OUTP:DIQ ON"
'Enables digital baseband output.
"INIT:IMM"
'Starts the measurement.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
6.144 Operating Manual 1313.9681.12 - 01