R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Example: "SYST:LANG 'SCPI'"
Characteristics: *RST value: 'SCPI'
SCPI: conform
Mode: A
There is no query for this command.
SYSTem:LXI:DISPlay ON|OFF
SYSTem Subsystem
This command shows or hides the LXI Observer dialog box. To use this command, the LXI Class C
functionality must be installed and enabled (for details see “LXI” on page 4.196).
Example: "SYST:LXI:DISP ON"
'Shows the LXI Observer dialog box.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
SYSTem:LXI:INFO?
This command queries the current parameters of the LXI class C.
Return value: | | | | |
Example: "SYST:LXI:INFO?"
’Queries the current parameters
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
SYSTem:LXI:LANReset
This command resets the LAN configuration to the values required by the LXI standard. In addition,
the password is reset to its initial state as well as the LXI instrument description.
Example: "SYST:LXI:LANR"
’Initiates a LAN reset.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
SYSTem:LXI:LCI
This command executes the LAN configuration initialize (LCI) on the instrument. To use this command,
the LXI Class C functionality must be installed and enabled (for details see “LXI” on page 4.196).
As of firmware version 4.5x, the LXI functionality has been expanded. Instead of this command, use
SYSTem:LXI:LANReset to reset the LAN configuration.
Example: "SYST:LXI:LCI"
'Sets the LAN configuration initialize (LCI).
Operating Manual 1313.9681.12 - 01 6.235