R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
MMEMory:SELect[:ITEM]:NONE
MMEMory Subsystem
This command deletes all data subsets from the list of device settings to be stored/loaded.
Example: "MMEM:SEL:NONE"
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value.
MMEMory:SELect[:ITEM]:SCData ON | OFF
This command adds the tracking generator calibration data to the list of device settings to be stored/
loaded.
Example: "MMEM:SEL:SCD ON"
'Inserts the tracking generator correction data in the list of data subsets
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
This command is only available in conjunction with option external generator control B10.
MMEMory:SELect[:ITEM]:TRACe[:ACTive] ON | OFF
This command adds the active traces to the list of data subsets of a save/recall device setting. Active
traces are all traces whose state is not blank.
Example: "MMEM:SEL:TRAC ON"
Characteristics: *RST value: OFF, i.e. no traces will be stored
SCPI: device-specific
Mode: A
MMEMory:SELect[:ITEM]:TRANsducer:ALL ON | OFF
This command includes all transducer factors and sets in the list of data subsets of a device setting to
be stored/loaded.
Example: "MMEM:SEL:TRAN:ALL ON"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: A
This command is available from firmware version 1.40 or higher.
MMEMory:STORe:MARKer
This command saves the data of all active markers to a file < file_name >.
Example: "MMEM:STOR:MARK 'C:\marker.txt'"
’Generates a MARKER.TXT file that contains all data of the active markers in
screen A.
If in screen A two markers are active, the gemerated MARKER.TXT file includes
the following:
6.140 Operating Manual 1313.9681.12 - 01