R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
Analyzer Mode
START MEAS Starts the Spectrum Emission Mask measurement. In Single Sweep mode, the
R&S FSQ automatically stops the measurement.
Remote command: INIT:ESP
STOP MEAS Stops the Spectrum Emission Maskj measurement.
CONTINUOUS
SWEEP
Remote command: ABOR
For more information see CONTINUOUS SWEEP.
SINGLE SWEEP For more information see SINGLE SWEEP.
LIST EVAL Opens a submenu to edit the list evaluation settings.
LIST EVAL
(ON OFF)
Activates or deactivates the list evaluation.
A peak search evaluation is performed automatically during the measurement. The
results are displayed in a table below the measurement diagram.
By default, the list evaluation is active.
The evaluation table shows the following results:
• frequency range
• frequency of the absolute peak power in the corresponding range.
• frequency of the peak power in the corresponding range.
• difference between the limit line and the current power level in dB.
• result of the limit check (color and an asterisk indicate a failed limit check).
The trace, limit line, result of the limit check and the channel power of the reference
range are displayed in full screen, too, if the LIST EVALUATION is inactive.
Remote command: CALC:ESP:PSE:AUTO ON
MARGIN Opens an edit dialog box to enter the margin used for the limit check/peak search.
IF SHIFT For more information see IF SHIFT.
SAVE AS
STANDARD
LIST EVAL (ON OFF)
MARGIN
Opens a dialog box to save customized configurations for spectrum emission mask
measurements. The R&S FSQ stores the configurations on its harddisk as an xml
file.
Remote command: ESP:STAN:SAVE 'filename'
Operating Manual 1313.9681.12 - 01 4.151