R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
Analyzer Mode
For both methods, the results are listed in tables in the lower half of the screen.
The R&S FSQ offers predefined standard settings which can be selected from a
table for the common mobile radio standards. Thus, channel configuration is performed
automatically without the need to enter the corresponding parameters manually.
For some standards, the channel power and the adjacent-channel power are to be
weighted by means of a root-raised cosine filter corresponding to a receive filter.
This type of filtering is switched on automatically for both methods on selecting the
standard (e.g. NADC, TETRA or 3GPP W-CDMA).
As of firmware version 4.3x it is possible to configure overlapping adjacent channels.
Based on a common carrier channel setting, it is now possible to measure with
two slightly different ADJ channel settings with one single measurement at the same
time.
Example:
ACP Measurement A and Measurement B are using identical TX channel settings
(Channel Bandwidth).
The ADJ settings for Measurement A and measurement B are different.
It is now possible to do both measurements at the same time.
• Configure the ACP measurement with number of ADJ channels = 2.
• Define ADJ settings (bandwidth, spacing) as required for measurement A.
• Define ALT1 settings (bandwidth, spacing) as required for ADJ channel of
measurement B
• Perform the ACP measurement
• Read the ACP measurement result
The Carrier Power belongs to measurement A and B
The ADJ result is the ADJ result of measurement A
The ALT1 result is the ADJ result of measurement B.
This feature is only supported for ACP but not for Multi Carrier ACP measurement.
4.86 Operating Manual 1313.9681.12 - 01