R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
INPut:DIQ:RANGe[:UPPer]
INPut Subsystem
This command defines the voltage corresponding to the maximum input value of the digital baseband
input ( value 7FFF hex).
The suffix is irrelevant.
Example: "INP:DIQ:RANG 1.2"
sets the voltage to 1.2 V.
Characteristics: *RST value: 1
SCPI: device-specific
Mode: A
INPut:DIQ:SRATe
This command defines the input date sample rate read by the digital baseband input.
The suffix is irrelevant.
Example: "INP:DIQ:SRAT 81.6 MHz"
sets the input sample rate to 81.6 MHz.
Characteristics: *RST value: 81.6 MHz
SCPI: device-specific
Mode: A
INPut:DIQ:SRATe:AUTO ON | OFF
This command controls the auto set function of the digital baseband input sample rate.
Depending on the digital baseband signal source, the sample rate of the I/Q data is passed to the
R&S FSQ LVDS input interface.
If the sample rate of the signal source is outside the R&S FSQ supported range, it shows the “BDI”
enhancement label. The “BDI” label is also visible if the signal source does not support automatic
matching.
Parameter: ON
Automatically matches the sample rate of the digital baseband input to that of the
signal source.
OFF
The R&S FSQ does not match the sample rate. You can set it manually with
“INPut:DIQ:SRATe”.
Example: "INP:DIQ:SRAT:AUTO OFF"
disbales automatic matching of the sample rate.
"INP:DIQ:SRAT 81.6MHZ"
sets the sample rate to 81.6 MHz.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
Operating Manual 1313.9681.12 - 01 6.129