R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
4.8.1 External Generator Settings
External Generator Control – Option R&S FSP-B10
NETWORK The NETWORK hotkey opens the menu for setting the functions of the external generator.
SOURCE
POWER
POWER
OFFSET
SOURCE POWER
POWER OFFSET
SOURCE CAL � CAL TRANS
FREQUENCY OFFSET
CAL REFL SHORT
CAL REFL OPEN
NORMALIZE
REF VALUE POSITION
REF VALUE
RECALL
SAVE AS TRD FACTOR
EXT SOURCE � EXT SRC ON / OFF
SELECT GENERATOR
FREQUENCY SWEEP
GEN REF INT / EXT
Other softkeys are available in the displayed menus for controlling the internal
tracking generator when option Tracking Generator R&S FSU-B9 is fitted. For
detailed information see section “Tracking Generator – Option R&S FSU-B9” on
page 4.221.
The SOURCE POWER softkey activates the entry of the generator output level. The
value range depends on the selected generator. For detailed information see “List of
Generator Types Supported by the R&S FSQ” on page 4.248.
If both option External Generator Control B10 and option Tracking Generator B9 are
installed, the softkey will modify the output power of the generator currently in use.
The default output power is -20 dBm.
Remote command: SOUR:EXT:POW –20dBm
The POWER OFFSET softkey activates the entry of a constant level offset of the
generator. With this offset, attenuator pads or amplifiers connected to the output
connector of the generator can be handled during the input and output of output levels.
The permissible setting range is -200 dB to +200 dB in steps of 0.1 dB. Positive offsets
handle a subsequent amplifier and negative offsets an attenuator pad.
The default setting is 0 dB; offsets 0 are marked by the activated enhancement
label LVL.
Remote command: SOUR:POW:OFFS -10dB
4.236 Operating Manual 1313.9681.12 - 01