R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
CALCulate:MARKer:MINimum:NEXT
CALCulate Subsystem
This command positions the specified marker to the next higher minimum value of the corresponding
trace.
Example: "CALC:MARK2:MIN:NEXT"
'Positions marker 2 in screen A to the next higher maximum value.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
CALCulate:MARKer:MINimum[:PEAK]
This command positions the specified marker to the current minimum value of the corresponding trace.
The corresponding marker is activated first or switched to marker mode, if necessary.
Example: "CALC:MARK2:MIN"
'Positions marker 2 in screen A to the minimum value of the trace.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
If no next higher minimum value is found on the trace (level spacing to adjacent
values < peak excursion), an execution error (error code: -200) is produced.
If no minimum value is found on the trace (level spacing to adjacent values < peak
excursion), an execution error (error code: -200) is produced.
This command is an event and therefore has no *RST value and no query.
CALCulate:MARKer:MINimum:RIGHt
This command positions the specified marker to the next higher minimum value to the right of the
current value (i.e. in ascending X direction) on the corresponding trace.
If no next higher minimum value is found on the trace (level spacing to adjacent
values < peak excursion), an execution error (error code: -200) is produced.
Operating Manual 1313.9681.12 - 01 6.49