R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
CALCulate:MARKer:FUNCtion:REFerence
CALCulate Subsystem
This command sets the reference level to the power measured by the indicated marker. If the selected
marker was used as delta marker, it is switched to marker mode.
Example: "CALC:MARK2:FUNC:REF"
'Sets the reference level of screen A to the level of marker 2.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event and therefore has no *RST value and no query.
CALCulate:MARKer:FUNCtion:TOI:MARKer CALCulate | SEARch
This command controls the positioning of the intercept markers 3 and 4 for TOI measurement, based
on the two carrier signals.
• CALCulate:
Calculates the intermodulation product frequencies.
• SEARch:
Performs a local peak search near the expected intermodulation product frequencies.
Example: "CALC:MARK:FUNC:TOI:MARK SEAR"
' selects TOI marker search mode
Characteristics: *RST value: CALC
SCPI: device-specific
Mode: A
CALCulate:MARKer:FUNCtion:TOI:RESult?
This command queries the third-order intercept point measurement in the indicated measurement
window.
A complete sweep with synchronization to sweep end must be performed between switching on the
function and querying the measured value to obtain a valid query result. This is only possible in singlesweep
mode.
The numeric suffix of :MARKer is irrelevant of this command.
Example: "INIT:CONT OFF"
'Switches to single-sweep mode.
"CALC:MARK:FUNC:TOI ON"
'Switches the intercept measurement in screen A.
"INIT;*WAI"
'Starts a sweep and waits for the end.
"CALC:MARK:FUNC:TOI:RES?"
'Outputs the measured value of screen A.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is only a query and therefore has no *RST value.
Operating Manual 1313.9681.12 - 01 6.61