R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
4.3 Mode Selection – Hotkey Bar
Mode Selection – Hotkey Bar
For fast mode selection the R&S FSQ has keys located under the measurement
screen, the so-called hotkeys. These hotkeys are displayed depending on the
options installed on the instrument. According to the selected mode, the corresponding
softkey menus are displayed (on the right side of the measurement screen).
In this section, only the hotkeys provided by the basic model are described. For
information on the other hotkeys refer to the corresponding option descriptions.
Fig. 4.1 Hotkey bar of the basic model
SPECTRUM The SPECTRUM hotkey sets R&S FSQ to analyzer mode. For details on the softkey
menus refer to section “Analyzer Mode” on page 4.9.
The analyzer mode is the default mode of R&S FSQ.
Remote command: INST:SEL SAN
INST:NSEL 1
MORE The MORE hotkey switches to side hotkey bar(s) and back to the main hotkey bar.
In the side hotkey bar(s), the hotkeys for the options are located. For further information
refer to the descriptions of the corresponding options.
SCREEN A /
SCREEN B
With the SCREEN A / SCREEN B hotkey two different settings can be selected on
the R&S FSQ in the FULL SCREEN display mode.
In the SPLIT SCREEN display mode the key switches between active diagram A
and B.
The key designation indicates the diagram which has been activated by means of
the key.
The currently active window is marked by
gram.
A or B
on the right of the dia-
Remote command: DISP:WIND:SEL
Operating Manual 1313.9681.12 - 01 4.7