R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
EXPORT /
IMPORT DEV
DATA
Basic Settings
The EXPORT DEV DATA softkey opens a dialog to export device specific data to a
memory stick.
The export function automatically creates a sub folder using the instrument name
and the serial number, e.g. FSQ40_123000 and copies device specific files to this
folder:
• Option license key codes
• Board specific data
• Frequency response correction file (option FSQ-B72 only)
IMPORT DEV DATA reads these data back onto the instrument.
Select the folder, where the instrument specific sub folder is located and press
OPEN. A dialog asks to perform a reboot when the import is done.
This function is helpful to backup device specific data, e.g. the option license keys. It
is also helpful if you have to use a removable flash disk (R&S FSQ-B18) for more
than one device. In this case:
• Export the instrument data of device 1.
• Switch instrument 1 off.
• Remove the flash disk from device 1.
• Insert the flash disk into device 2.
• Switch instrument 2 on
• Import the instrument data of device 2 (saved before).
Note that a new export of the specific instrument data is required whenever:
• A new option key was inserted.
• The Rohde & Schwarz Service refitted a board.
• The Rohde & Schwarz Service performed a device calibration.
Remote command: ---
Selftest
SELFTEST The SELFTEST softkey initiates the selftest of the instrument modules.
With this function the instrument is capable of identifying a defective module in case
of failure.
During the selftest a message box appears in which the current test and its result is
shown. The test sequence can be aborted by pressing ENTER ABORT.
All modules are checked consecutively and the test result (selftest PASSED or
FAILED) is output in the message box.
SELFTEST
RESULTS
Remote command: *TST?
The SELFTEST RESULTS softkey calls the SELFTEST table in which the results of
the module test are displayed.
4.202 Operating Manual 1313.9681.12 - 01