R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
CALCulate:MARKer:Y:PERCent 0 to100%
CALCulate Subsystem
This command positions the selected marker in the selected window to the given probability. If marker
2, 3 or 4 is selected and used as a delta marker, it is switched to marker mode.
Example: "CALC1:MARK:Y:PERC 95PCT"
'Positions marker 1 in screen A to a 'probability of 95%.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
CALCulate:MARKer:Y?
This command queries the measured value of the selected marker in the indicated measurement
window. The corresponding marker is activated before or switched to marker mode, if necessary.
To obtain a valid query result, a complete sweep with synchronization to the sweep end must be
performed between the activation of the marker and the query of the y value. This is only possible in
single-sweep mode.
The query result is output in the unit determined with the CALCulate:UNIT:POWer command.
Only with linear level scaling is the output in %.
Example: "INIT:CONT OFF"
'Switches to single-sweep mode.
"CALC:MARK2 ON"
'Switches marker 2 in screen A.
"INIT;*WAI"
'Starts a sweep and waits for the end.
"CALC:MARK2:Y?"
'Outputs the measured value of marker 2 in screen A.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
The command is only available with the CCDF measurement switched on.
The associated level value can be determined with the CALC:MARK:X? command.
Operating Manual 1313.9681.12 - 01 6.53