R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Instrument Functions
EDIT TRD
FACTOR
Basic Settings
The EDIT TRD FACTOR softkey gives access to the submenu for editing and generating
transducer factors. For details refer to section “Entry and Editing of Transducer
Factors” on page 4.179.
NEW FACTOR The NEW FACTOR softkey gives access to the submenu for editing and generating
transducer factors. For details refer to section “Entry and Editing of Transducer Factors”
on page 4.179.
DELETE
FACTOR
VIEW
TRANSDUCER
REFLVL ADJ
AUTO MAN
The DELETE FACTOR softkey deletes the marked factor.
To prevent deletion by mistake, deletion has to be confirmed.
Remote command: CORR:TRAN DEL
The VIEW TRANSDUCER softkey activates the display of the active transducer factor
or set. During the measurement, the interpolated characteristic of the active
transducer factor or set is shown in the diagram instead of the measured values.
Remote command: CORR:TRAN:VIEW ON
When a transducer factor is used, the trace is moved by a calculated shift. However,
an upward shift reduces the dynamic range for the displayed values. With the softkey
REFLVL ADJ an automatic reference level offset adaptation allows to restore
the original dynamic range by also shifting the reference level by the maximum
value of the transducer factor.
If transducers are active the function is automatically set to AUTO to obtain the best
dynamic performance.
Remote command: CORR:TRAN:SEL 'FACTOR1'
CORR:TRAN:ADJ:RLEV ON | OFF
PAGE UP The PAGE UP softkey is used to scroll through large tables that cannot completely
be displayed on the screen.
PAGE DOWN The PAGE DOWN softkey is used to scroll through large tables that cannot completely
be displayed on the screen.
Entry and Editing of Transducer Factors
A transducer factor is characterized by the following:
• Reference values with frequency and factor (Values)
• Unit of the factor (Unit) and
• Name (Name) to distinguish the various factors.
During entry the R&S FSQ checks the transducer factor for compliance with specific
rules that must be met to ensure correct operation.
• The frequencies for the reference values must always be entered in ascending
order. Otherwise the entry will not be accepted and the following message is
displayed:
WRONG FREQUENCY SEQUENCE !
Operating Manual 1313.9681.12 - 01 4.179