R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
DIAGnostic:SERVice:INPut:PULSed[:STATe] ON | OFF
DIAGnostic Subsystem
This command toggles the calibration signal in the selected measurement window between pulsed and
non-pulsed.
The selection takes effect only if the RF input has been set to the internal reference signal using the
DIAGnostic:SERVice:INPut[:SELect] command.
Example: "DIAG:SERV:INP CAL"
"DIAG:SERV:INP:PULS ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
DIAGnostic:SERVice:INPut:RECTangle:PRATe
This command sets the frequency of the rectangle calibration signal in the selected measurement
window (suffix ).
5 kHz | 31.25 kHz | 50 kHz | 250 kHz | 500 kHz can be set.
Example: "DIAG:SERV:INP:RECT:PRAT 128 MHz"
Characteristics: *RST value: 5 kHz
SCPI: device-specific
Mode: A
DIAGnostic:SERVice:INPut:RECTangle[:STATe] ON | OFF
This command switches the rectangle calibration signal on or off in the selected measurement window
(suffix ). The setting takes effect only if the RF input is set to the internal reference signal (DIAG:
SERV:INP CAL command).
Example: "DIAG:SERV:INP CAL"
"DIAG:SERV:INP:RECT ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
DIAGnostic:SERVice:INPut[:SELect] CALibration | RF
This command toggles between the RF input on the front panel and the internal 128 MHz reference
signal in the selected measurement window. The level of the 128-MHz signals can be selected by
DIAGnostic:SERVice:CSOource[:POWer] command.
Example: "DIAG:SERV:INP CAL"
’ Selects the internal reference signal.
Characteristics: *RST value: RF
SCPI: device-specific
Mode: A
If the rectangle calibration signal is switched on, the pulsed calibration signal is
switched off.
6.104 Operating Manual 1313.9681.12 - 01