R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
SYSTem:DISPlay:FPANel ON | OFF
SYSTem Subsystem
This command activates or deactivates the display of the front panel keys on the screen.
With the display activated, the instrument can be operated on the screen using the mouse by pressing
the corresponding buttons. This may be useful if the instrument is operated in a detached station by
means of a remote program such as PCANYWHERE.
Example: "SYST:DISP:FPAN ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
SYSTem:DISPlay:UPDate ON | OFF
This command switches on or off the update of all display elements during remote control.
Example: "SYST:DISP:UPD ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
SYSTem:ERRor?
This command queries the earliest entry in the error queue, and deletes it after the readout.
Positive error numbers indicate device-specific errors, negative error numbers are error messages
defined by SCPI (cf. chapter “Error Messages”). If the error queue is empty, the error number 0, "no
error", is returned. This command is identical with the command STATus:QUEue:NEXT?.
This command is a query and therefore has no *RST value.
Example: "SYST:ERR?"
Characteristics: *RST value: –
SCPI: conform
Mode: A
With the display of the front panel keys activated, the screen resolution of the unit
is set to 1024x768. Thus, only a section of the whole screen is visible on the internal
LCD display, which will be moved by mouse moves.
For a full display of the user interface, an external monitor has to be connected to
the rear panel.
When the front panel display is deactivated, the original screen resolution is
restored.
The best performance is obtained when the display output is switched off during
remote control.
Operating Manual 1313.9681.12 - 01 6.231