R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
CALCulate Subsystem
"INIT;*WAI"
'Starts a new measurement and waits for the sweep end.
"CALC:LIM:ACP:ACH:RES?"
'Queries the limit check result in the second alternate adjacent channels in
screen A.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
CALCulate:LIMit:ACPower:ALTernate[:RELative] 0 to 100dB, 0 to 100dB.
This command defines the limit for the alternate adjacent channels in the selected measurement
window for adjacent channel power measurements. The reference value for the relative limit value is
the measured channel power.
The numeric suffix after ALTernate denotes the alternate channel. The numeric suffixes
are irrelevant for this command.
It should be noted that the relative limit value has no effect on the limit check as soon as it is below the
absolute limit defined with CALCulate:LIMit:ACPower:ALTernate:ABSolute. This
mechanism allows automatic checking of the absolute basic values of adjacent channel power as
defined in mobile radio standards.
Parameter: The first value is the limit for the lower and the upper alternate adjacent channel.
The second limit value is ignored but must be indicated for reasons of compatibility
with the FSE family.
Example: "CALC:LIM:ACP:ALT2 30DB, 30DB"
'Sets the relative limit value in screen A for the power in the lower and upper
alternate adjacent channel to 30 dB below the channel power.
Characteristics: *RST value: 0DB
SCPI: device-specific
Mode: A
CALCulate:LIMit:ACPower:ALTernate[:RELative]:STATe ON | OFF
This command activates the limit check for the alternate adjacent channels in the selected
measurement window for adjacent channel power measurements. Before the command, the limit
check must be activated using CALCulate:LIMit:ACPower:STATe ON.
The numeric suffix after ALTernate denotes the alternate channel. The numeric suffixes
are irrelevant for this command.
The result can be queried with CALCulate:LIMit:ACPower:ALTernate:RESult?. It
should be noted that a complete measurement must be performed between switching on the limit
check and the result query, since otherwise no valid results are obtained.
Example: "CALC:LIM:ACP:ALT2 30DB, 30DB"
'Sets the relative limit value in screen A for the power in the lower and upper
second alternate adjacent channel to 30 dB below the channel power.
"CALC:LIM:ACP:ALT2:ABS -35DBM, -35DBM"
'Sets the absolute limit value in screen A for the power in the lower and upper
second alternate adjacent channel to -35 dBm.
6.34 Operating Manual 1313.9681.12 - 01