R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
[SENSe:]CORRection:CVL:CATalog?
This command queries all the names of the conversion loss tables saved on the hard disc.
The syntax of the output is:
,,
,,,,...,,
,
Example: ":CORR:CVL:CAT?"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is only available if option R&S FSU-B21 is installed.
[SENSe:]CORRection:CVL:CLEar
SENSe Subsystem
This command deletes the selected Conversion Loss Table. Prior to this command, the command
SENS:CORR:CVL:SEL must be sent.
Example: "CORR:CVL:SEL 'LOSS_TAB'"
"CORR:CVL:CLE"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is an event which is why it is not assigned an *RST value.
This command is only available with the option R&S FSU-B21.
[SENSe:]CORRection:CVL:COMMent
This command defines the comment in the Conversion Loss Table. Prior to this command, the
command SENS:CORR:CVL:SEL must be sent.
Parameter: ::= Comment of mixer with a maximum of 60 characters
Example: "CORR:CVL:SEL 'LOSS_TAB'"
"CORR:CVL:COMMENT 'MIXER FOR BAND U'"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
This command is only available with the option R&S FSU-B21.
[SENSe:]CORRection:CVL:DATA ,..
This command defines the reference values of the selected Conversion Loss Tables. The values are
entered as a result of frequency/level pairs. The frequencies have to be sent in ascending order. A
maximum of 50 pairs of frequency/level may be entered. Prior to this command, the command SENS:
CORR:CVL:SEL must be sent.
Example: "CORR:CVL:SEL 'LOSS_TAB'"
"CORR:CVL:DATA 1MHZ,-30DB,2MHZ,-40DB"
6.154 Operating Manual 1313.9681.12 - 01