R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Characteristics: *RST value: --
SCPI: instrument-specific
Mode: A-F, A-T
SENSe Subsystem
The measurement function always uses trace 1 in the selected screen, and activates
the selected screen.
Repeated use of the command without changes to its parameters (i.e. using the
same settings again) will speed up the measurement since the previous hardware
settings will be cached and therefore additional hardware settling times will be
avoided. This also holds true if only part of the parameters (e.g. only the trigger
delay) are changed, as in this case the rest of the parameters will be cached.
This measurement is not compatible with other measurements, especially as far
as marker functions, adjacent channel measurement or statistics are concerned.
The corresponding functions are therefore automatically switched off. In return
incompatible commands will automatically deactivate the multi burst power function.
The function is only available in the remote control. It is deactivated on switching
back to LOCAL.
If available also the RRC and the CFILer filter type can be used by defining it with
the command ”BAND|BWID:TYPE NORM | FFT | CFIL | RRC“ before using
the MPOW command.
6.194 Operating Manual 1313.9681.12 - 01