R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
[SENSe:]SWEep:EGATe:SOURce EXTernal | IFPower
SENSe Subsystem
This command toggles between external gate signal and IF power signal as a signal source for the
gate mode. If an IF power signal is used, the gate is opened as soon as a signal at > -20 dBm is
detected within the IF path bandwidth (50 MHz).
Example: "SWE:EGAT:SOUR IFP"
'Switches the gate source to IF power.
Characteristics: *RST value: IFPower
SCPI: device-specific
Mode: A
[SENSe:]SWEep:EGATe:TRACeCOMMent
To enter a comment string in the gate range table.
The suffix after TRACe indicates the trace.
Example: "SWE:EGAT:TRAC2:COMMent"
’To enter a comment in trace 2.
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
[SENSe:]SWEep:EGATe:TRACePERiod
The period of the signal is set for the gate range table.
The suffix after TRACe indicates the trace.
Example: "SWE:EGAT:TRAC1:PER 5ms"
’Period of trace 1 is set to 5 ms.
Characteristics: *RST value: 1.797693135E+308
SCPI: device-specific
Mode: A
[SENSe:]SWEep:EGATe:TRACeSTARt | STOP
Sets the start or stop value of a gate range in the gate range table.
The suffix after TRACe indicates the trace.
The suffix after STARt | STOP indicates the range.
Example: "SWE:EGAT:TRAC1:STAR2 5us"
’Start value of range 2, trace 1 is set to 5 µs.
Characteristics: *RST value: 1.797693135E+308
SCPI: device-specific
Mode: A
[SENSe:]SWEep:EGATe:TRACeSTATe ON | OFF
The gate range in the gate range table is set on or off.
The suffix after TRACe indicates the trace.
The suffix after STATe indicates the range.
6.208 Operating Manual 1313.9681.12 - 01