R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
6.16.10 SENSe:MIXer Subsystem
SENSe Subsystem
The SENSe:MIXer subsystem controls the settings of the external mixer. It is only active if option
R&S FSU-B21 is installed.
[SENSe:]MIXer:BIAS:HIGH
This command sets the bias current of the mixer for higher harmonics in bands with two harmonics.
Example: "MIX ON"
"MIX:BIAS:HIGH 7mA"
Characteristics: *RST value: 0 A
SCPI: conform
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
[SENSe:]MIXer:BIAS[:LOW]
This command sets the bias current for the active band. If two harmonics are used for the band, it is
set for the lower harmonic.
Example: "MIX ON"
"MIX:BIAS 7mA"
Characteristics: *RST value: 0 A
SCPI: conform
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
[SENSe:]MIXer:HARMonic 2 to 64
With band USER, this command sets the nth harmonic. The command may be a query with waveguide
bands.
Parameter: := 2.. 64: ( max depending on the LO)
Example: "MIX ON"
"MIX:HARM 5"
Characteristics: *RST value: 2
SCPI: conform
Mode: A
This command is only available for option R&S FSU-B21 and external mixer activated.
[SENSe:]MIXer:HARMonic:BAND A|Q|U|V|E|W|F|D|G|Y|J|USER
This command sets the active band.
Example: "MIX ON"
"MIX:HARM:BAND E"
Characteristics: *RST value: U
SCPI: device-specific
Mode: A
6.186 Operating Manual 1313.9681.12 - 01