R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Command Known Differences
RQS Supported bits:
1 (Units key pressed)
2 (End of Sweep)
3 (Device error)
4 (Command complete)
5 (Illegal command)
SRCNORM
SRCPWR
SP Default value, range, step size
SS Default value, range, step size
ST Default value, range, step size
GPIB Commands of HP Models 856xE, 8566A/B, 8568A/B and 8594E
STB The status bits are mapped as described with command RQS.
Bit 2 and 4 are always set in parallel if "Command Complete" or "End of Sweep"
are recognized. The R&S FSQ cannot distinguish between these conditions. Additionally
these bits are not suitable for synchronization on the end of sweep in continuous
sweep operation.
TA Output of 1001 trace points of trace A in O1 or O3 format.
TB Output of 1001 trace points of trace B in O1 or O3 format.
TH Default value
VB Range
VBR Default value
6.280 Operating Manual 1313.9681.12 - 01