R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
On SRQ:
'Response to service request
SENSe:MPOWer:RESult:MIN?
Characteristics: *RST value: --
SCPI: instrument-specific
Mode: A-F, A-T
SENSe Subsystem
[SENSe:]MPOWer[:SEQuence] ,,,,
,,,
This command configures the instrument setup for multiple burst power measurement and starts a
measurement sequence. When synchronizing the command with *OPC, a service request is
generated as soon as the defined number of individual measurements (# of meas) is reached.
To reduce the setting time, the setup is performed simultaneously for all selected parameters.
The command in the form of a query makes the instrument settings, performs the defined number of
measurements and outputs the measurement results list.
Parameter:
Receive frequency for the burst signals to be measured (= center frequency in
manual operation) The range is 0 Hz to max. frequency, depending on instrument
model
Resolution bandwidth for the measurement
The range is from 10 Hz to 20 MHz in steps of 1, 2 3, 5, 10 steps and, additionally
a bandwidth of 50 MHz.
Time span during which measurement samples are sampled for RMS / peak
measurement The type of measurement is selected by . The range
is from 1 us to 30 s.
Possible settings of the trigger signal source are:
EXTernal:
The trigger signal is fed from the "Ext. Trigger/Gate" input on the rear of the unit.
VIDeo:
The internal video signal is used as trigger signal.
IFPower:
The internal IF signal with 10 MHz bandwidth is used as the trigger signal.
Signal level at which the trigger becomes active.
For = VIDeo this is the level of the video signal as a percentage
of the diagram height.
For = IFPower this is the signal level in dBm.
If = EXTernal is selected, the value entered here is ignored, as in
this case the trigger input uses the normal trigger settings made via the TRIG key.
The range for trigger source video is 0 – 100PCT.
6.192 Operating Manual 1313.9681.12 - 01