R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
CALCulate:MARKer:FUNCtion:SUMMary:MEAN:RESult?
CALCulate Subsystem
This command queries the result of the measurement of the mean value in the selected measurement
window.
The function is independent of the marker selection, i.e. the numeric suffix of :MARKer is
irrelevant. It is only available in the time domain (span = 0).
A complete sweep with synchronization to sweep end must be performed between switching on the
function and querying the measured value to obtain a valid query result. This is only possible in singlesweep
mode.
Example: "INIT:CONT OFF"
'Switches to single-sweep mode.
"CALC:MARK:FUNC:SUMM:MEAN ON"
'Switches on the function in screen A.
"INIT;*WAI"
'Starts a sweep and waits for the end.
"CALC:MARK:FUNC:SUMM:MEAN:RES?"
'Outputs the result of screen A.
Characteristics: *RST value: -
SCPI: device-specific
Mode: A-T
This command is only a query and therefore has no *RST value.
CALCulate:MARKer:FUNCtion:SUMMary:MEAN[:STATe] ON | OFF
This command switches on or off the measurement of the mean value in the selected measurement
window.
The function is independent of the marker selection, i.e. the numeric suffix of :MARKer is
irrelevant. It is only available in the time domain (span = 0).
Example: "CALC:MARK:FUNC:SUMM:MEAN ON"
'Switches on the function in screen A.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A-T
The measurement is performed on the trace on which marker 1 is positioned. In
order to evaluate another trace, marker 1 must be positioned on another trace with
CALC:MARK:TRAC 1|2|3.
CALCulate:MARKer:FUNCtion:SUMMary:MODE ABSolute | RELative
This command selects absolute or relative time domain power measurement in the indicated
measurement window. The function is independent of the marker selection, i.e. the numeric suffix
of :MARKer is irrelevant. It is only available in the time domain (span = 0).
The reference power for relative measurement is defined with CALCulate:MARKer:FUNCtion:
SUMMary:REFerence:AUTO ONCE. If the reference power is not defined, the value 0 dBm is used.
Operating Manual 1313.9681.12 - 01 6.83