R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
CALCulate:MARKer:FUNCtion:FPEaks:SORT X | Y
This command sets the sort mode for the search for maxima.
CALCulate Subsystem
Parameter: X: the maxima are sorted in the list of responses according to increasing X values
Y: the maxima are sorted in the list of responses according to decreasing Y values
The numeric suffix at MARKer is irrelevant.
Example: "CALC:MARK:FUNC:FPE:SORT Y"
'sets the sort mode to decreasing y values
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
CALCulate:MARKer:FUNCtion:FPEaks:STATe ON | OFF
This command activates or deactivates the peak list.
Once a search has been performed, the peak list is available even if the peak list is turned off (state
OFF). The following commands therefore still return results:
• CALCulate:MARKer:FUNCtion:FPEaks:COUNt?
• CALCulate:MARKer:FUNCtion:FPEaks:X?
• CALCulate:MARKer:FUNCtion:FPEaks:Y?
• TRACe[:DATA] FPEaks
Example: "CALC:MARK:FUNC:FPE:STAT ON"
activates the peak list.
"CALC;MARK:FUNC:FPE:LIST:SIZE 10"
sets the number of peaks to 10.
"INIT;*WAI"
starts a measurement ans synchronizes to the end of the sweep.
"TRAC? FPE"
queries the peak list
"CALC:MARK:FUNC:FPE:STAT OFF"
turns the peak list off.
"TRAC? FPE"
queries the peak list stored in the memory.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
CALCulate:MARKer:FUNCtion:FPEaks:X?
This query reads out the list of X values of the maxima found. The number of available values can be
queried with CALC:MARK:FUNC:FPEaks:COUNt?.
With sort mode X, the X values are in increasing order; with sort mode Y the order corresponds to the
decreasing order of the Y values.
Example: "CALC:MARK:FUNC:FPE:SORT Y"
'sets the sort mode to decreasing y values
6.66 Operating Manual 1313.9681.12 - 01