R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
DISPlay[:WINDow]:TRACe:Y[:SCALe]:RLEVel:OFFSet -200dB to 200dB
DISPlay Subsystem
This command defines the offset of the reference level in the selected measurement window.
Depending on the coupling of the measurement windows, it is valid for both screens or only for the
selected measurement window (INSTrument:COUPle).
The numeric suffix at TRACe is irrelevant.
Example: "DISP:TRAC:Y:RLEV:OFFS -10dB"
Characteristics: *RST value: 0dB
SCPI: conform
Mode: A
DISPlay[:WINDow]:TRACe:Y[:SCALe]:RPOSition 0 to 100PCT
This command defines the position of the reference value in the selected measurement window. The
numeric suffix in TRACe is irrelevant.
In NETWORK mode (Tracking Generator/Ext. Generator Option R&S FSU-B9/R&S FSP-B10) with
active normalization, RPOSition defines the reference point for the output of the normalized
measurement results.
Example: "DISP:TRAC:Y:RPOS 50PCT"
Characteristics: *RST value:
100PCT(analyzer mode)
50 PCT (NETWORK mode)
Characteristics: SCPI: conform
Mode: A
DISPlay[:WINDow]:TRACe:Y[:SCALe]:RVALue
If the tracking generator option or the external generator control option (R&S FSU-B9/R&S FSP-B10)
is available and the normalization in the NETWORK mode is activated, this value defines the power
value assigned to the reference position in the selected measurement window. This value corresponds
to the parameter REFERENCE VALUE in manual operation.
The numeric suffix at TRACe is irrelevant.
Example: "DISP:TRAC:Y:RVAL 0"
'Sets the power value assigned to the reference position to 0 dB (Tracking
Generator/Ext. Generator Control option).
Characteristics: *RST value:
0 dB (NETWORK mode)
Mode: A
DISPlay[:WINDow]:TRACe:Y:SPACing LINear | LOGarithmic | LDB
This command toggles between linear and logarithmic display in the selected measurement window.
On a linear scale, switch over between the unit % (command DISP:WIND:TRAC:Y:SPAC LIN) and
the unit dB (command DISP:WIND:TRAC:Y:SPAC LDB) is also possible.
If the FM demodulator (R&S FS-K7) is active and result display AF spectrum of FM, AM or PM is
selected, only the parameters LINear and LOGarithmic are permissible.
The numeric suffix in TRACe is irrelevant.
Operating Manual 1313.9681.12 - 01 6.113