R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
6.20 TRACe Subsystem
The TRACe subsystem controls access to the instrument's internal trace memory.
6.20.1 General Trace Commands
TRACe:COPY TRACE1| TRACE2| TRACE3 , TRACE1| TRACE2| TRACE3
TRACe Subsystem
This command copies data from one trace to another. The second operand describes the source, the
first operand the destination of the data to be copied.
The numeric suffix at TRACe selects the measurement window.
Example: "TRAC:COPY TRACE3,TRACE1"
Characteristics: *RST value: -
SCPI: conform
Mode: A
This command is an event and therefore has no query and no *RST value.
TRACe[:DATA] TRACE1 | TRACE2 | TRACE3 | FPEaks | LIST | SPURious, |
This command transfers trace data from the control computer to the instrument, the query reads trace
data out of the instrument.
The numeric suffix at TRACe selects the measurement window.
Parameter: TRACE1 | TRACE2 | TRACE3
Selects the trace you want to copy the data to or the trace you want to query the
data of.
LIST
The parameter LIST queries the results of the peak list evaluation for spurious
emission and spectrum emission mask measurements. You can define the ranges
for spurious measurements with the commands starting with “SENSe:LIST:
RANGe:” and for SEM measurements with the commands starting with
“SENSe:ESPectrum:RANGe”.
For every range that you have defined (range 1 to n), the command returns eight
values in the following order.
,,,,,,,
,,,
No Range number
Start Range start frequency
Stop Range stop frequency
Rbw Resolution bandwidth
Freq Frequency of the peak in the range
Levelabs Absolute peak power of the range in dBm
Levelrel Reserved (0.0)
Delta Delta of the peak power to the limit line in dB
Limitcheck Limit check state (0 = PASSED, 1 = FAILED)
Unused1 Reserved (0.0)
Unused2 Reserved (0.0)
Operating Manual 1313.9681.12 - 01 6.239