R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
6.5.5.3 CALCulate:LIMit:CONTrol Subsystem
The CALCulate:LIMit:CONTrol subsystem defines the x-axis (CONTrol-axis).
CALCulate Subsystem
CALCulate:LIMit:CONTrol[:DATA] ,.
This command defines the x-axis values (frequencies or times) of the upper or lower limit lines.
The values are defined independently of the measurement window.
In analyzer mode, the unit of values depends on the frequency or time domain of the x-axis, i.e. it is
HZ with CALC:LIM:CONT:DOM FREQ and S with CALC:LIM:CONT:DOM TIME.
Example: "CALC:LIM2:CONT 1MHz,30MHz,100MHz, 300MHz,1GHz"
'Defines 5 reference values for the x-axis of limit line 2.
"CALC:LIM2:CONT?"
'Outputs the reference values for the x-axis of limit line 2 separated by a comma.
Characteristics: *RST value: - (LIMit:STATe is set to OFF)
SCPI: conform
Mode: A
CALCulate:LIMit:CONTrol:DOMain FREQuency | TIME
This command defines the frequency or time domain for the x-axis values.
Example: "CALC:LIM2:CONT:DOM TIME"
'Defines the time domain for the x-axis of limit line 2.
Characteristics: *RST value: FREQuency
SCPI: device-specific
Mode: A
CALCulate:LIMit:CONTrol:MODE RELative | ABSolute
This command selects the relative or absolute scaling for the x-axis of the selected limit line. The
definition is independent of the measurement window.
Example: "CALC:LIM2:CONT:MODE REL"
'Defines the x-axis of limit line 2 as relatively scaled.
Characteristics: *RST value: ABSolute
SCPI: device-specific
Mode: A
Operating Manual 1313.9681.12 - 01 6.37