R&S FSQ Signal Analyzer - Rohde & Schwarz

R&S FSQ Remote Control – Description of Commands
Example: "CALC:MARK:X:SLIM ON"
'Switches the search limit function on for screen A.
"CALC:MARK:X:SLIM:RIGH 20MHz"
'Sets the right limit of the search range in screen A to 20 MHz.
CALCulate Subsystem
Characteristics: *RST value: - (is set to the right diagram border on switching on search limits)
SCPI: device-specific
Mode: A
CALCulate:MARKer:X:SLIMits[:STATe] ON | OFF
This command switches between a limited (ON) and unlimited (OFF) search range in the selected
measurement window. The function is independent of the selection of a marker, i.e. the numeric suffix
MARKer is irrelevant.
If the time domain power measurement is active, this command limits the evaluation range on the
trace.
Example: "CALC:MARK:X:SLIM ON"
'Switches on search limitation in screen A.
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
CALCulate:MARKer:X:SSIZe STANdard | POINts
This command defines the marker step size when you change the position of a marker with the rotary
knob.
The numeric suffixes at CALCulate and MARKer are irrelevant.
Parameter: STANdard
The step size of the marker is one pixel.
POINts
The step size of the marker is one sweep point.
The number of sweep points in a trace depends on the number of sweep points you
have set.
Example: "CALC:MARK:X:SSIZ POIN"
'The step size of the marker is one sweep point.
Characteristics: *RST value: STANdard
SCPI: device-specific
Mode: A
The function is only available if the search limit for marker and delta marker is
switched on (CALC:MARK:X:SLIM ON).
6.52 Operating Manual 1313.9681.12 - 01